If You Desire a Mounted Engine

use only good, heavy-channeled and well-braced trucks. especially designed for the type engine we furnish. When engine is in operation put wedged blocks in front and behind each wheel.  In taking up bearings on saw tables, follow instructions given on page 18.

CAPACITY OF FUEL TANKS

The fuel tank of the stationary engine is located in the base. The 1 3/4 H. P. tank holds 1.1 gal Ions; 2 1/2 H.P. tank holds 1.4 gallons 3 1/2 H.P. tank holds 1.6 gallons; 6 H.P. tank holds 3.1 gal-Ions; 8 H.P. tank holds 5.8 gallons; 10 H P. tank holds 8 gallons; 14 H.P. tank holds 12.6 gallons.

Rule for Figuring the Size of Pulleys

Be Sure You Are Using the Right Pulleys on Engine and Machines it is Driving. The machines you run with an engine, to give you satisfactory service, must he equipped with the proper size of pulley to correspond with the pulley on the engine.

To be sure that the pulleys you are using are of the right size to give the best results. take the speed of the engine multiplied by the size of the pulley on the engine and divide the result by the speed of the machine that you want to run The result will give you the size of the pulley you should have on the machine.

For example - We will say the speed of the engine is 425 revolutions per minute, the diameter of the pulley on the engine is 12 inches and you want to run a feed grinder 510 revolutions per minute. 425X12=5100/510=10 inches.

The result. 10 inches, is the size of the pulley you should have on the grinder to run it 510 revolutions per minute.

If there is a pulley on the machine you want to run, to find out what size of pulley to use on the engine, take the speed of the machine multiplied by this diameter of the pulley on the machine and divide by the speed of the engine you are going to use, which will give the size of pulley you should have on the engine to give the best results.

For example - Suppose you had a feed grinder that you wanted to run at 510 revolutions per minute. The diameter of the pulley is 10 inches and your engine runs 425 revolutions per minute  510x10=5100/425=l2 inches.

The result. 12 inches, is the size of the pulley you should have on the engine to run the grinder at 510 revolutions per minute.

Of course, you understand the pulley sizes and the speed of the machine will vary a little one way or the other. When figuring the size of pulley to use, if the result shows an odd size take the nearest even size. which will be all right. For example. if the above result should have been 11 1/2 inches, you would use a l2 inch pulley, but if the result had been 10 1/2 inches. then a 10 inch pulley should be used. In case the result should be just half way between regular sizes, we advise using the nearest larger even size.